well now I'll give some old articles that might be useful ...
please refer to the following steps to install the CPU...
- Please Turn Off the power and unplug the power cord before installing the CPU. Pull the lever sideways away from the socket. make sure to raise the lever up to a 90 degree angle.
- look for the gold arrow. The gold arrow should point towards the lever pivot. The CPU can only fit ini the correct orientation.
- If the CPU correctly installed, the pins should be completely embedded into socket an can not be seen. Please not that any violation of the correct installation procedures may cause permanent damages to your mainboard.
- press the CPU down firmly into the socket and close the lever, As the CPU is likely to move while the lever is being closed, always close the lever with your fingers pressing tighty on top of the CPU to make sure the CPU is properly and completely embedded into the socket.
- position the CPU cooler set on to the CPU.
- use one end of the clip to hook the latch of the CPU sliding plate and then hook the other three latch to fix the cooling fan set. At Last, connect the fan to the power supply connector provided on your mainboard...
This old article so hopefully useful ...
Tidak ada komentar:
Posting Komentar